Post by Beans on Feb 11, 2013 23:50:02 GMT -5
When I first learned how to port match this video helped me out a lot.
cms.skunk2.com/id/469/Skunk2-How-To-Throttle-Body-Port-Matching/4/
What you will need:
A couple of things. If you don't have a scribe you can use a permanent marker like so:
Bolt up tb to intake manifold. Make sure it is bolted on the right way!
Make sure to clean the intake manifold thoroughly afterwards with soap and water! The last thing you want is little aluminum shards going into the combustion camber.
cms.skunk2.com/id/469/Skunk2-How-To-Throttle-Body-Port-Matching/4/
What you will need:
- Sharpie
- Intake manifold
- Throttle body with hardware
- Air compressor
- Die Grinder
- Aluminum Bits
- A steady hand
A couple of things. If you don't have a scribe you can use a permanent marker like so:
Bolt up tb to intake manifold. Make sure it is bolted on the right way!
Make sure to clean the intake manifold thoroughly afterwards with soap and water! The last thing you want is little aluminum shards going into the combustion camber.
